Оценок - 2, средний балл: 4.5 ( )

Инструкция по эксплуатации Dixon Marking Tools, модель ZTR 428

Производитель: Dixon Marking Tools
Размер: 88.33 kb
Название файла:
Язык инструкции:en
Перейти к скачиванию

Фрагмент инструкции

This will place the initial start up of the engine in a no load situation and allow complete engine lubrication. Adjustment; 1. Install engine to Mower deck drive belt (P/N 6111). 2. Check and adjust tire pressures. Front 19 to 21 psi; Rear 8 to 12 psi. Tires May have been over inflated for shipping purposes. 3. Place the Mower on a level surface. Using the lift handle, raise the Mower deck to a height which will allow Measurements to be taken from the surface to the tops of the two outer Mower deck cutter blades (P/N 8688). 4. Align both outer Mower deck cutter blades to obtain a side to side Measurement. Starting with the left blade as viewed from operator’s position, secure Measurement from level surface to the bottom of the - cutter blade tip, rotate blade and check Measurement on opposite end of cutter blade. Tip to tip measurement on the same cutter blade should not vary more than 1/8th of an inch. Maintain measurement taken and verify against the right outer cutter blade. If adjustment is required, loosen or tighten the nuts on the two rear L-rods. 5. Align both outer mower deck cutter blades front to rear as viewed from operator’s position. Measure from surface to the bottom of the cutter blade tip, at the rear of the mower deck. Using the nut on the single front L-rod, loosen or tighten as required to place the mower deck at an attitude of approximately l/8th of an inch higher in the rear than the front of the deck. 6. Recheck belt routing and alignment, start engine, burnish in electric blade clutch using at least (5) engagements at 3/4 to full throttle settings. Each engagement should last approximately (6) seconds. Note; The completed adjustment places the mower deck in an attitude or position which will produce a quality cut. Ground speed, grass conditions, types of grass, tire pressures, dull or bent blades and loose belts are just some of the factors which will cause poor cut quality. Pixonl DIXON INDUSTRIES, INC. Box1569 Coffeyville, Kansas 67337-0945 (316)251-2000 Airport Industrial Park TELEX 417100...

Эта инструкция также подходит к моделям:
Газонокосилки - ZTR 429 (88.33 kb)

Напишите ваш отзыв об устройстве

Текст отзыва
Ваше имя:
Введите две цифры: