The load attached to the ZRW113 is not affected. If you associate Z-Wave devices into Group 3, you can turn those devices on or off by tapping the switch on or off three times. You can brighten or dim devices by tapping the switch on or off twice and then holding the switch. The load attached to the ZRW113 is not affected. You can associate up to 5 Z-Wave devices into each of these groups. For instructions on how to “associate” a Z-Wave device into one of these groups, refer to your wireless con
The proper operation of this node in the mesh network is dependent on it knowing its location with respect to other nodes. You cannot “test bench” configure this module, then install. The ZRW113 Isolated Contact Wall Mounted 3-Way Switch is a component of the HomePro lighting control system. Wire the Wall Mounted Switch in place of the standard wall switch according to the diagram above and program from the Wireless Controller to operate loads. Inclusion of this Switch on the ZTH100 Wireless Con
Quando il prodotto diventa inutilizzabile, portalo nel punto di raccolta stabilito dalle autorita locali. Alcuni punti di raccolta accettano i prodotti gratuitamente. La raccolta separata e il riciclaggio del prodotto al momento dello smaltimento aiutano a conservare le risorse naturali e assicurano che venga riciclato nel rispetto della salute umana e dell’ambiente. Europeiska unionen—uttjanta produkter Symbolen ovan betyder att produkten enligt lokala lagar och bestammelser inte far kastas til
See the service and support information that came with your Apple product. Or, consult an experienced radio or television technician for additional suggestions. Important: Changes or modifications to this product not authorized by Apple Inc. could void the FCC compliance and negate your authority to operate the product. This product was tested for FCC compliance under conditions that included the use of Apple peripheral devices and Apple shielded cables and connectors between system components.
This dual-speed hub contains two internal repeater buses – one for 10Mbps traffic and another for 100Mbps traffic. Traffic passing between attached devices that operate at the same speed is confined within the appropriate repeater bus. The components of the Zilla Hub are shown in the figure below: Zilla Hub Check the Package The Zilla Hub includes: • 1 Zilla Hub • 1 DC Power Adapter • This user guide • 1 registration card (please return) RJ-45 Connectors Accton’s Zilla Hub features 8 10BASE-T/10
To determine whether a later edition exists, or to request copies of publications, contact: ZiLOG Worldwide Headquarters 532 Race Street San Jose, CA 95126 Telephone: 408.558.8500 Fax: 408.558.8300 Document Disclaimer ZiLOG is a registered trademark of ZiLOG Inc. in the United States and in other countries. All other products and/or service names mentioned herein may be trademarks of the companies with which they are associated. ©2005 by ZiLOG, Inc. All rights reserved. Information in this publi
• Security button: The Security button has two functions: -Secure the Powerline network. -Automatically connect your wireless client to the XWN5001 WiFi access point. Install the Adapters and Surf the Web with WiFi 1. Secure your Powerline network. a.Make sure that the Power LED is solid green on each Powerline device. b. On the XAV5602 adapter, press its Security button for 2 seconds, and then release the button. The Power LED blinks green while the adapter is setting up security. c. Within 2 m
200 Mbps Powerline technology. Create a high-speed WiFi N access point via the 500 Mbps Powerline technology Extend WiFi coverage across walls and floors for Internet access Ideal for connecting tablets, smartphones and laptops to Internet Create a high-speed WiFi N access point via the 500 Mbps Powerline technology Compact and elegant design to fit with your surroundings Automatic push button wireless setup Pick-a-Plug LED identifies best outlet for optimal performance Push-and-secure button fo