Войти:
Скачали: 0   Размер: 565 kb   Производитель: Panasonic  
Категория: Пульт ду
@name

Tally Indicator (REC/TALLY) When the Remote Control Box (RCB) is used in conjuction with a Special Effects Generator, the Tally Indicator inside the viewfinder as well as this indicator on the Remote Control Box (RCB) will light to indicate that recording is in progress. Note: When using the Remote Control Box (RCB) in the Remote Control Unit (RCU), the recording start/stop function is not available. 154. Monitor Output Connector As this connector is in parallel connection with the VIDEO 2

Скачали: 0   Размер: 139 kb   Производитель: La Crosse Technology  
Категория: Пульт ду
@name

3. Press and release the “SNOOZE” button to confirm the time setting and to advance to DST (Daylight Saving Time) setting. D. TIME ZONE SETTING 1. Hold down the “MODE/MIN” button for 3 seconds, the time will flash in the Time LCD. 2. Press and release the “SNOOZE” button to advance to the time zone selection. 3. In the indoor temperature/humidity section of the LCD the time zone will flash. 6 4. Press and release the “MODE/MIN” button to select the appropriate time zone. There are 24 time zones

Скачали: 0   Размер: 95 kb   Производитель: La Crosse Technology  
Категория: Пульт ду
@name

The alarm repeats automatically after 24 hours. Page 4 of8 If the “ SNZ” button is pressed, the alarm will silence for approximately 5 minutes, after which it will begin to sound again. The alarm uses 3 different patterns of tone, beginning gently and increasing in intensity, known as a "Crescendo Alarm" . Battery Replacement Information To replace the battery: 1. Lift up the battery compartment cover and remove the battery. 2. Please take note to install the battery with the proper polarity as

Скачали: 0   Размер: 139 kb   Производитель: La Crosse Technology  
Категория: Пульт ду
@name

NOTE: The above steps are not required but can help the projection alarm receive the signal faster. 3. Place the batteries into the projection alarm clock. 4. DO NOT PRESS ANY BUTTONS FOR 15 MINUTES. NOTE: It is important to not press any buttons after inserting batteries as this will interrupt the WWVB search sequence. In this time the display will show both the indoor temperature and humidity. If the station does not display both indoor temperature and indoor humidity after the 15 minutes plea

Скачали: 0   Размер: 95 kb   Производитель: La Crosse Technology  
Категория: Пульт ду
@name

All replaced parts and products become the property of La Crosse Technology, Ltd and must be returned to La Crosse Technology, Ltd. Replacement parts and products assume the remaining original warranty, or ninety (90) days, whichever is longer. La Crosse Technology, Ltd will pay all expenses for labor and materials for all repairs covered by this warranty. If necessary repairs are not covered by this warranty, or if a product is examined which is not in need or repair, you will be charged for th

Скачали: 0   Размер: 139 kb   Производитель: La Crosse Technology  
Категория: Пульт ду
@name

2. It is also highly recommended to set the projection alarm in a window or other area free of interference in the area of your home that is closest to Colorado (the source of the WWVB signal). NOTE: The above steps are not required but can help the projection alarm receive the signal faster. 3. Place the batteries into the projection alarm clock. 4. DO NOT PRESS ANY BUTTONS FOR 15 MINUTES. NOTE: It is important to not press any buttons after inserting batteries as this will interrupt the WWVB s

Скачали: 0   Размер: 95 kb   Производитель: La Crosse Technology  
Категория: Пульт ду
@name

Battery: Battery problems are the single largest cause of customer support cases. A few things to check: . Use a fresh battery Please use a plain Alkaline battery that tests no less than 1.48 on a voltmeter or with an expiration date that is 7 years in the future. . Ensure correct polarity Ensure that the clock has a fresh battery and is installed using correct polarity as shown inside the battery compartment (+ ). Online Resources Warranty Information Visit the WT-8002 page online at: http: / /

Скачали: 0   Размер: 139 kb   Производитель: La Crosse Technology  
Категория: Пульт ду
@name

This time does not follow Daylight Saving Time changes. After the top of the minute, a tone will sound for every second. It is possible that your projection alarm may not be exactly on the second due to the variance in the quartz. However, the clock will adjust the quartz timing over the course of several days to be very accurate; under 0.10 seconds per day. 3 QUICK SET-UP GUIDE Hint: Use good quality Alkaline Batteries and avoid rechargeable batteries. 1. We recommend beginning the set-up proce

Скачали: 0   Размер: 95 kb   Производитель: La Crosse Technology  
Категория: Пульт ду
@name

Do not submerge the unit in water. Furthermore, fix all parts in place where the units are adequately protected against moisture and rain. Special care shall be taken when handling a damaged LCD display. The liquid crystals can be harmful to user's health. Do not make any repair attempts to the unit. Contact the La Crosse Technology ® Warranty Department for help. Opening and tampering with the unit may invalidate their guarantee. Never touch the exposed electronic circuit of the device as there

Скачали: 0   Размер: 139 kb   Производитель: La Crosse Technology  
Категория: Пульт ду
@name

2. Press and release the “AL/HOUR” button to advance the hours and press and release the “MODE/MIN” button to advance the minutes. NOTE: “A.M.” or “P.M.” will be displayed to the left of the time to help identify the time. 3. Press and release the “SNOOZE” button to confirm the time setting and to advance to DST (Daylight Saving Time) setting. D. TIME ZONE SETTING 1. Hold down the “MODE/MIN” button for 3 seconds, the time will flash in the Time LCD. 2. Press and release the “SNOOZE” button to ad





Категории