Оценок - 2, средний балл: 4.5 ( )

Инструкция по эксплуатации La Crosse Technology, модель XG-20

Производитель: La Crosse Technology
Размер: 95 kb
Название файла:
Язык инструкции:en
Перейти к скачиванию

К этому устройству также есть другие инструкции:

Фрагмент инструкции

Replace only with new batteries of the recommended type. When cleaning the display and casings, use a soft damp cloth only. Do not use solvents or scouring agents as they may mark the LCD and casings. Do not submerge the unit in water. Furthermore, fix all parts in place where the units are adequately protected against moisture and rain. Special care shall be taken when handling a damaged LCD display. The liquid crystals can be harmful to user's health. Do not make any repair attempts to the unit. Contact the La Crosse Technology ® Warranty Department for help. Opening and tampering with the unit may invalidate their guarantee. Never touch the exposed electronic circuit of the device as there is a danger of electric shock should it become exposed. Do not expose the units to extreme and sudden temperature changes, as this may lead to reduce their accuracy. Mounting the Unit Troubleshooting The clock can be set on a table or mounted onto a wall. Table Standing An easel type foldout stand is located on the bottom of the back side of the clock. Pull the easel out from the bottom to open it. Wall Mounting Select a place to mount the clock. Install a mounting screw (not included). Align the hanging hole to the mounting screw and ensure that the clock locks down into place before releasing it. Battery: Battery problems are the single largest cause of customer support cases. A few things to check: . Use a fresh battery Please use a plain Alkaline battery that tests no less than 1.48 on a voltmeter or with an expiration date that is 7 years in the future. . Ensure correct polarity Ensure that the clock has a fresh battery and is installed using correct polarity as shown inside the battery compartment (+ ). Online Resources Warranty Information Visit the WT-8002 page online at: http: / / lacrossetechnology. com/ 8002 Care and Maintenance Extreme temperatures, vibration and shock should be avoided as these may cause damage to the unit and give inaccurate readings. Precautions shall be taken when handling batteries. Injuries, burns, or property damage may be resulted if batteries are in contact with conducting materials, heat, corrosive materials or explosives. Batteries should be taken out of the unit before it is stored for a long period of time. Page 5 of 8 La Crosse Technology, Ltd provides a 1-year limited warranty on this product against manufacturing defects in materials and workmanship. This limited warranty begins on the original date of purchase, is valid only on products purchased and used in North America and only to the original purchaser of this product. To receive warranty service, the purchaser must contact La Crosse Technology, Ltd for problem determination and service procedures. Warranty service can only be performed by a La Crosse Technology, Ltd authorized service center. The original dated bill of sale must be presented upon request as proof of purchase to La Crosse Technology, Ltd or La Crosse Technology, Ltd’s authorized service ...

Эта инструкция также подходит к моделям:
Пульт ду - Radio Controlled Projection Alarm WT-5110 (95 kb)
Пульт ду - Radio Controlled Projection Alarm WT-5350 (95 kb)
Пульт ду - TIMER WALL WT-8100 (95 kb)

Напишите ваш отзыв об устройстве

Текст отзыва
Ваше имя:
Введите две цифры: