Войти:
Скачали: 0   Размер: 228 kb   Производитель: Lennox Hearth  
Категория: Двери и окна
@name

Consult your local distributor for fi replace code information. NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE. 1110 West Taft Avenue • Orange, CA 92865 Figure 5 - COMPLETED INSTALLATION Swing the bottom of the doorframe inward, then push into place Figure 4 - INSTALL DOORFRAME 3. Remove the arched screen doorframe from packaging, then install it as follows: a. Locate slots on each side of fi replace. b. Position the top of the doorframe above the top of the glass door assembly (centered and ap

Скачали: 0   Размер: 228 kb   Производитель: Lennox Hearth  
Категория: Двери и окна
@name

A 04/2006 INSTALLATION INSTRUCTIONS FOR DECORATIVE ARCH SCREEN PANEL KIT FOR USE WITH LMDV-33/35/40, MPD-33/35/40, MPB-35/40, SSDV-35/40, SSBV-35/40, MPD35ST, MPB35ST, EDV-4035, EDVST AND EBVST GAS FIREPLACES DECORATIVE ARCH SCREEN PANEL KIT CAT# MODEL DESCRIPTION H3592 DASPK33TI 33” Decorative Arch Screen Panel H3593 DASPK35TI 35” Decorative Arch Screen Panel H3594 DASPK40TI 40” Decorative Arch Screen Panel Table 1 KIT CONTENTS QUANTITY DESCRIPTION 1 ea Arched Doorframe Assembly 1 ea. Instructi

Скачали: 0   Размер: 228 kb   Производитель: Lennox Hearth  
Категория: Двери и окна
@name

Ensure the glass door assembly on the fireplace is properly aligned as follows: a. Open or remove lower compartment door (refer to Homeowner’s Manual provided with appliance). Note: Units with Modesty Panels - Remove the modesty panel as follows: Lift the modesty panel by the tab on the panel’s right end, pull the right end of the panel away from cabinet and then pull the panel diagonally out of the corner post slots on the left side of the unit. Remove the modesty panel carefully, so that none

Скачали: 1   Размер: 91 kb   Производитель: BEA  
Категория: Двери и окна

Скачали: 0   Размер: 115 kb   Производитель: Heath Zenith  
Категория: Двери и окна
@name@name@name

If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not change the plug in any way. 2. Plug-in the doorbell chime. Chime Volume Control 1. Set the chime volume on the back of the plug-in chime, if desired. 3. Before mounting, test the doorbell range. Plug-in the chime where you want to mount it and temporarily place the doorbell button on the doorjamb. Press the doorbell button. Access Door Ope

Скачали: 3   Размер: 115 kb   Производитель: Heath Zenith  
Категория: Двери и окна
@name@name@name

If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not change the plug in any way. 2. Plug-in the doorbell chime. Chime Volume Control 1. Set the chime volume on the back of the plug-in chime, if desired. 3. Before mounting, test the doorbell range. Plug-in the chime where you want to mount it and temporarily place the doorbell button on the doorjamb. Press the doorbell button. Access Door Ope

Скачали: 3   Размер: 531 kb   Производитель: Heath Zenith  
Категория: Двери и окна
@name@name@name

Snap the front of the button back on. When attaching the doorbell button using the double sided tape, make sure the surface of the door jamb or wall is clean. © 2003 DESA Specialty Products™ 595-5707-04 The chime can be mounted by using the 3 holes in the back of the case, or by using 2 screws with the keyholes. Chime Back Case Keyhole Mounting Chime Back Case Mounting Close Chime Case From Bottom Snap the front of the chime case back on. Start with the bottom edge of the case aligned wi

Скачали: 0   Размер: 502 kb   Производитель: Heath Zenith  
Категория: Двери и окна
@name@name@name

2. Install the 3 alkaline "D" batteries. Make sure the batteries are oriented properly. 3. Before mounting, test the doorbell range. Put the chime where you want to mount it and temporarily place the doorbell button on the doorjamb. Press the doorbell button. Operation Press the doorbell button to verify that the doorbell and chime work properly. If the chime does not sound see the Troubleshooting guide on page 4. 4. Mount the doorbell button and chime. Use either screws or double sided tape to

Скачали: 1   Размер: 539 kb   Производитель: Heath Zenith  
Категория: Двери и окна
@name@name@name

It is recommended to only change one jumper at a time and then check to see if system is functioning properly. Note: Jumpers in positions 1 through 7 must be exactly the same for both the transmitter and chime for this system to function. -4-595-5345-06 Tune Settings Your Heath®/Zenith wireless chime has different selectable tunes: Ding (one note), Ding-Dong (two note), or Westminster (eight note) (Available on selected Heath®/Zenith chimes). The factory setting is for the Ding-Dong tune (or Wes

Скачали: 2   Размер: 174 kb   Производитель: Heath Zenith  
Категория: Двери и окна
@name@name@name

In typical use, alkaline batteries will last up to three years. 2. Install 3 alkaline "D" batteries. Make sure batteries are oriented properly. 1. Install alkaline type A23 12 volt push button battery. Remove back of case by pushing in tab on bottom with a small screwdriver. Make sure battery is oriented properly (see page 3). 3. Test range. Temporarily position chime and push button where you want them mounted. Press push button to verify chime and push button work properly. If chime does not s





Категории