Войти:
Скачали: 12   Размер: 2 mb   Производитель: Desa  
Категория: Камины
@name

If glass is broken, wear gloves and tape the remaining fragments onto the frame. 1. Remove screen assembly by pushing the rod either left or right and then down and forward to remove screen/rod assembly from the firebox. Set assembly aside. 2. Lift up on latches to unlock. There are two on top of firebox and two below firebox that hold glass door in place (see Figure 42). 3. While holding glass door to prevent it from falling and causing injury, remove the five screws from the hinge located on t

Скачали: 7   Размер: 2 mb   Производитель: Desa  
Категория: Камины
@name

Cut Siding Away to Fit Standoff Wood Screw Standoff Vent Cap Apply Mastic to All Four Sides Screws Figure 11 - Installing Siding Standoff (Combustible Exterior) Firestop Vent Cap Horizontal (Horizontal Vent Pipe Termination) Screw Interior Wall Surface Wall Figure 12 - Connecting Vent Cap with Horizontal Vent Pipe Wood Screw Vent Cap Figure 10 -Installing Horizontal Vent Cap (Noncombustible Exterior) 116238-01A 10 VENTING INSTALLATION INSTRUCTIONS Installation Planning (Cont.) VENTING INSTALLATI

Скачали: 1   Размер: 2 mb   Производитель: Desa  
Категория: Камины
@name

If you have conflicting gas types, do not install fireplace. See retailer where you purchased the fireplace for proper fireplace according to your gas type or to purchase gas conversion kit (see Accessories, page 35). Installing optional blower accessories NOTICE: If installing blower in an existing fireplace with gas connections, shut off gas supply and disconnect heater from gas supply. Contact a qualified service person to do this. WARNING: If there is a duplex electrical outlet installed in

Скачали: 22   Размер: 2 mb   Производитель: Desa  
Категория: Камины
@name

Follow the gas supplier's instructions • if you cannot reach you gas supplier, call the fire department. 4. Never install the fireplace • in a recreational vehicle • in windy or drafty areas where curtains or other combustible(flammable) objects can make contact with the fireplacefront • in high traffic areas 116226-01A 33 116226-01A SAFETY INFORMATION Continued PRODUCT IDENTIFICATION Figure 1 - Direct-Vent Fireplace with Millivolt Ignition LOCAL CODES Install and use fireplace with care. Follow

Скачали: 6   Размер: 2 mb   Производитель: Desa  
Категория: Камины
@name

A. This appliance is equipped with an ignition device which automatically lights the pilot. Do not try to light the pilot by hand. B. BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor. WHAT TO DO IF YOU SMELL GAS • Do not try to light any appliance. • Do not touch any electric switch. • Do not use any phone in your building. • Immediately call your gas supplier from a neighbor.s phone.

Скачали: 3   Размер: 2 mb   Производитель: Desa  
Категория: Камины
@name

Horizontal High Wind Square Termination Screws 45° Elbow Wall Firestop Wall Firestop Maintain 1" Minimum Air Space Around Outer Pipe When Penetrating a Wall High Wind Termination Square Termination Vertical (V) Horizontal (H) 32 3/4" min. 17" max. Apply Mastic to Outside Edge of Standoff 10 3/4" x 10 3/4" Framed Opening 45° Elbow Exterior Portion of Wall Firestop (Round Termination Only) Exterior Wall with Vinyl Siding Wall Firestop Figure 13 - Typical Horizontal Termination Cap Mounting with Ad

Скачали: 0   Размер: 2 mb   Производитель: Desa  
Категория: Камины
@name

4. Assemble the desired combination of pipe and elbows to the fireplace flue collar. If there are long portions of venting run, pre-assembled pipe sections may be installed as subassemblies for convenience. 5. Carefully determine the location where the vent pipe assembly will penetrate the outside wall. The center of the hole should line up with the center-line of the horizontal vent pipe. Mark the wall for a 10 3/4" x 10 3/4" square hole. Cut and frame the square hole in the exterior wall where

Скачали: 3   Размер: 2 mb   Производитель: Desa  
Категория: Камины
@name

You can now turn the burner on and off with the hand-held remote control unit. IMPORTANT: Do not leave the selector switch in the REMOTE or ON position when the pilot is not lit. This will drain the battery. Blower Control Knob (Optional Accessory) Variable Control Knob Selector Switch in Remote Position Gas Control Knob in ON Position Figure 46 - Setting the Selector Switch, Gas Control Knob and Variable Control Knob for Remote Operation 116239-01B OPERATING FIREPLACE Optional Hand-Held Remote

Скачали: 6   Размер: 2 mb   Производитель: Desa  
Категория: Камины
@name

Have a qualified technician replace pilot line 6. Replace control valve (Refer to Replacement Parts, page 28) 7. Check that main power is on and that all wire connections are made correctly to the ignition model (see Wiring Diagram, page 23). Check for 24 VAC at the secondary side of the transformer. If 24 VAC is present and the module does not operate, have the module replaced otherwise have the transformer replaced 1. Check wiring connection. Refer to wiring diagram (see Wiring Diagram, page 2

Скачали: 1   Размер: 2 mb   Производитель: Desa  
Категория: Камины
@name

16. Close glass door and lock latches on top and bottom of door and replace screen. See Removing Glass Door, steps 5 and 6, page 25. 17. Replace top and bottom louvers. WALL SWITCH INSTALLATION The installation of a wall switch allows you to activate the gas control valve and turn the fireplace on and off. The wall switch is to be connected to the incoming 120 volt regular household wiring that supplies the electricity to the fireplace. optional Remote control INSTALLATION (model WRC) Note: If u





Категории