Войти:
Скачали: 0   Размер: 2 mb   Производитель: Majestic Appliances  
Категория: Газовые нагреватели
@name

This heater shall not be installed in a confined space or unusually tight construction unless provisions are provided for adequate combustion and ventilation air. This appliance is for supplemental heating only. It should not be used as the primary heat source for a dwelling. The National Fuel Gas Code, ANSI Z233.1/NFPA 54 defines a confined space as a space whose volume is less than 50 cubic feet per 1,000 Btu per hour (4.8m3 per kw) of the aggregate input rating of all appliances installed in

Скачали: 4   Размер: 166 kb   Производитель: Lochinvar  
Категория: Газовые нагреватели

Скачали: 4   Размер: 166 kb   Производитель: Lochinvar  
Категория: Газовые нагреватели

Скачали: 0   Размер: 6 mb   Производитель: Enerco  
Категория: Газовые нагреватели
@name

When ordering parts, follow the instructions listed under Replacement Parts on page 20 of this manual. ITEMPART NO.DESCRIPTIONQTY. IR10NGBF6NG BF10NG * Item Not Shown ** Must purchase assembly NON-Thermostat models 42 3 1-1 IR10NG 1-4 1-3 5 10 26 22-1 6 8 35 1-2 23 22-3 13 2 7 43 44 38 24 40 36 16-1 29-1 21 16-2 16 1-1 42 BF6NG BF10NG 3 5 1-3 1-2 6 15 1-4 26 14 22-1 8 23 44 16-2 16 4 27-2 13 7 16-1 22-3 24 2 REPLACEMENT PARTS Note: use only original replacement parts. This will protect you warra

Скачали: 0   Размер: 6 mb   Производитель: Enerco  
Категория: Газовые нагреватели
@name

8. Reconnected fittings must be checked for leaks in next section. Test Pressure Equal To or Less Than . psig (3.5 kPa) 1. Close equipment shutoff valve (see figure 13). 2. Pressurize supply piping system by either using compressed air or opening main gas valve on or near gas meter. 3. Check all joints from the gas meter to equipment shutoff valve (see figure 14). Apply mixture of liquid soap and water to gas joints. Bubbles forming show a leak. 4. Correct all leaks at once. 5. Depressurize and

Скачали: 0   Размер: 6 mb   Производитель: Enerco  
Категория: Газовые нагреватели
@name

To clean these parts we recommend using compressed air no greater than 30 psig. This can be done by using a vacuum cleaner in the blow position, using compressed air in a can, please follow the directions on the can. If you don’t follow directions on the can you could damage the burner or pilot assembly. In addition, the directions that follow should also be followed. 1. Shut off the unit, including the pilot. Allow the unit to cool for at least thirty minutes. 2. Inspect burner and pilot for du

Скачали: 0   Размер: 6 mb   Производитель: Enerco  
Категория: Газовые нагреватели
@name

IR20NGTBF20NGTIR30NGTBF30NGT ** Not sold separately – Must purchase Assembly * Items not shown 17030070300 70300 Cabinet Assembly1 1-1 70301 70301 70301 Cabinet Top Panel 1 1-2 70302 70302 70302 Cabinet Right Panel 1 1-3 70303 70303 70303 Cabinet back Panel 1 1-4 70304 70304 70304 Cabinet Left Panel 1 2 70305 70305 70305 Lower Front panel assembly 1 3 70312 70312 70312 Reflector Assembly 1 4 --- 70319 70319 Burner Assembly 1 5 70320 70320 70320 Wall Mounting Bracket 1 6 70321 70321 70321 Valve M

Скачали: 2   Размер: 6 mb   Производитель: Enerco  
Категория: Газовые нагреватели
@name

Air in gas line 3. Air passageways on heater blocked 4. Dirty or partially clogged burner orifice. 1. When heated, vapors from furniture polish, wax, carpet cleaners, etc., turn into white powder residue 1. Clean burner orifice (see Cleaning and Maintenance on page 13), or replace burner orifice 2. Replace burner 3. Replace gas regulator 1. Replace burner 2. Turn control knob until it locks at desired setting. 3. Replace gas regulator 1. Problem will stop after a few hours of operation 1. Turn c

Скачали: 10   Размер: 6 mb   Производитель: Enerco  
Категория: Газовые нагреватели
@name

2. Mark screw locations on wall (see figure 7). 3. Remove tape and mount bracket from wall. Figure 7 Attaching to Wall Stud: For attaching mounting bracket to wall studs 1. Drill holes at marked locations using 9/64” drill bit. 2. Place mounting bracket onto wall. Line up holes on each end of bracket with hole drilled in wall. 3. Insert mounting screws through bracket and into wall studs. 4. Tighten screws until mounting bracket is firmly fastened to wall studs. Attaching to Wall using Anchor: F

Скачали: 0   Размер: 6 mb   Производитель: Enerco  
Категория: Газовые нагреватели
@name

A. This appliance has a pilot that must be lighted by hand. When lighting the pilot, follow these instructions exactly. B. BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor. WHAT TO DO IF YOU SMELL GAS • Do not try to light any appliance. • Do not touch any electrical switch; do not use any phone in your building. • Immediately call you gas supplier from a neighbor’s phone. Follow the





Категории