Войти:
Скачали: 2   Размер: 2 mb   Производитель: White  
Категория: Швейные машинки
@name

This will re lease the pressure on the presser foot. To increase the pressure, push down inner pin until suitable pressure is obtained. Insufficient pressure may cause poor feeding of the fabric, skipped stitches, or difficulty in guiding the fabric. If feed dogs or presser foot marks appear on the fabric, reduce the pressure. When sewing multiple thickness or heavy fabric, reduce the pressure. Increase pressure when sewing lighter weight fabrics. —15— abric. thread and needle table THREAD NEEDL

Скачали: 12   Размер: 18 mb   Производитель: Brother  
Категория: Швейные машинки

Скачали: 46   Размер: 18 mb   Производитель: Brother  
Категория: Швейные машинки
@name

34 VORPROGRAMMIERTE STICHE VORPROGRAMMIERTE STICHE Gratenstich Dekorstiche Stichname Stichmuster Stich lange [mm (Zoll)] Stichbreite [mm (Zoll)] 37 27 Gratenstich24 19 Fest 2,5 (3/32) 3-6,5 (1/8-1/4) Verwenden Sie den Gratenstich als Dekorstich auf der Stoffoberseite beim Sticken oder beim Einsaumen von Decken, Tischdecken oder Vorhangen. 1 Legen Sie den Stoff mit der rechten Seite nach oben und nahen Sie im Abstand von 1 cm (1/2 Zoll) von der Kante des Stoffes. 2 Schneiden Sie nahe an der Naht.

Скачали: 69   Размер: 2 mb   Производитель: Brother  
Категория: Швейные машинки
@name

When connecting the foot controller, be sure to turn off the sewing machine in order to prevent the machine from accidentally being started. When you press the foot controller down lightly, the machine will run at a low speed. When you press harder, the machine’s speed will increase. When you take your foot off the foot controller, the machine will stop. Slower Faster You should make sure that nothing is placed on the foot controller when the machine is not in use. CAUTION . Do not allow pieces

Скачали: 23   Размер: 2 mb   Производитель: Brother  
Категория: Швейные машинки
@name

a Notch b Bobbin winder shaft spring b Slide the bobbin winder shaft to the right. Follow steps a through g of the procedure c in “Winding the bobbin” to pass the thread around the pre-tension disk (page 14). d While holding the thread that wraps around the pre-tension disk with your left hand, use your right hand to wind the free end of the thread clockwise around the bobbin five or six times. 17 KNOWING YOUR SEWING MACHINE KNOWING YOUR SEWING MACHINE Pull the thread to the right and pass it th

Скачали: 3   Размер: 2 mb   Производитель: Brother  
Категория: Швейные машинки
@name@name

. Do not turn on the machine while pressing down the foot controller. The machine may start unexpectedly and cause personal injury or damage to the machine. 1Turn on (toward the ‘I’ mark) 2Turn off (toward the ‘O’ mark) CAUTION ¦Checking the needle correctly Put the flat side of the needle on a flat surface. Check the needle from the top and the sides. Dispose of any bent needles safely. 21 Foot controller When you press the foot controller down lightly, the machine will run at a low speed. When

Скачали: 11   Размер: 2 mb   Производитель: Brother  
Категория: Швейные машинки

Скачали: 60   Размер: 12 mb   Производитель: Brother  
Категория: Швейные машинки

Скачали: 15   Размер: 12 mb   Производитель: Brother  
Категория: Швейные машинки
@name

6 Optional accessories ........................................................................................................................................ 7 Accessory compartment ................................................................................................................................... 7 NAMES OF MACHINE PARTS AND THEIR FUNCTIONS .................................................... 8 The main parts .....................................................................

Скачали: 82   Размер: 2 mb   Производитель: Brother  
Категория: Швейные машинки
@name

a Sewing speed controller Turn on the sewing machine. i When the bobbin begins spinning slowly, take your foot off the foot controller or (start/stop button) (for models equipped with the start/stop button). . When the foot controller is plugge e start/stop button cannot be used to sewing (only for models equipped start/stop button). . If the sewing machine is to be ope using the foot controller, connect the foot controller before turning on the mac g h the stop button) (for models equipped with





Категории