Войти:
Скачали: 0   Размер: 955 kb   Производитель: Epson  
Категория: Шлифовальные станки
@name@name@name

It is important to remember two things about electronic speed control: 1. The electronic speed control operates only when the trigger switch (C) is fully depressed. 2. The effect of electronic speed control is much easier to observe at lower speed settings (2600 RPM and below), than at high speeds. As the tool approaches 3000 RPM, the effect is considerably less dramatic. Keep in mind that, with a conventional polisher running at a typical no load speed of 2400 RPM, the tool slows down to about

Скачали: 0   Размер: 129 kb   Производитель: Epson  
Категория: Шлифовальные станки
@name@name@name

WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals known to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are: • lead from lead-based paints, • crystalline silica from bricks and cement and other masonry products, and • arsenic and chromium from chemically-treated lumber (CCA). Your risk from these exposures varies, depending on how often you do this type of work. To reduce your

Скачали: 0   Размер: 165 kb   Производитель: Epson  
Категория: Шлифовальные станки
@name@name@name

CLEANING AND DISPOSAL a. All surfaces in the work area should be vacuumed and thoroughly cleaned daily for the duration of the sanding project. Vacuum filter bags should be changed frequently. b. Plastic drop cloths should be gathered up and disposed of along with any dust chips or other removal debris. They should be placed in sealed refuse receptacles and disposed of through regular trash pick-up procedures. During clean up, children and pregnant women should be kept away from the immediate wo

Скачали: 0   Размер: 2 mb   Производитель: Epson  
Категория: Шлифовальные станки
@name@name@name

2. Apply minimum pressure to the work surface, to operate at high speed. Grinding rate is greatest operates at high speed. 3. Maintain a 20° to 30° angle between the tool and work surface. 4. Continuously move the tool in a forward and back motion to avoid creating gouges in the work surface. 20°-30° 5. Remove the tool from work surface before turning tool off. Allow the tool to stop rotating before laying it down. EDGE GRINDING WITH GRINDING WHEELS CAUTION: Wheels used for cutting and edge grin

Скачали: 5   Размер: 3 mb   Производитель: Epson  
Категория: Шлифовальные станки
@name@name@name

15 Three Year Limited Warranty DEWALT will repair, without charge, any defects due to faulty or workmanship for three years from the This warranty does not cover part failure due abuse. For further detail of warranty coverage and information, visit or call 1-800-4-DEWALT (1-800433- 9258). This warranty does not apply to accessories or damage caused where repairs have been made or attempted by This warranty gives you specific legal rights and you may other rights which vary in certain states or p

Скачали: 7   Размер: 4 mb   Производитель: Epson  
Категория: Шлифовальные станки
@name

3. DRESS PROPERLY. Do not wear tie, gloves, or loose clothing. Remove watch, rings, and other jewelry. Roll up your sleeves. Clothing or jewelry caught in moving parts can cause injury. 4. DO NOT USE THE MACHINE IN A DANGEROUS ENVIRONMENT. The use of power tools in damp or wet locations or in rain can cause shock or electrocution. Keep your work area well-lit to prevent tripping or placing arms, hands, and fingers in danger. 5. MAINTAIN ALL TOOLS AND MACHINES IN PEAK CONDITION. Keep tools sharp





Категории