Войти:
Скачали: 2   Размер: 412 kb   Производитель: Ryobi  
Категория: Рубанки
@name

1. Unplug the planer. 2. Slide the collar of the dust bag onto the exhaust port. NOTE: To remove the dust bag, pull it straight out of the exhaust port. CAUTION: The dust bag fills quickly. Empty it often to prevent damage to the product. ADJUSTING THE EXHAUST DIRECTION See Figure 3. Control the direction of debris when working in confined areas. Change the direction of the exhaust to either the right or left. Follow these steps to adjust the exhaust direction. 1. Unplug the planer. 2. Adjust th

Скачали: 1   Размер: 848 kb   Производитель: Ryobi  
Категория: Рубанки
@name

Consequently, it is not recommended that this tool be used for extended work on any fiberglass material, wallboard, spackling compounds, or plaster. During any use on these materials, it is extremely important that the tool is cleaned frequently by blowing with an air jet. WARNING: Always wear safety goggles or safety glasses with side shields during power tool operation or when blowing dust. If operation is dusty, also wear a dust mask. 13 MAINTENANCE MAINTENANCE LUBRICATION All of the bearings

Скачали: 1   Размер: 1 mb   Производитель: Ryobi  
Категория: Рубанки
@name

127 mm 318 mm 5 - 153 mm 3 mm 8m / min 48mm with 2 blades, 9000 R.P.M. ie 18000 C.P.M. 32 - 30.5 kg Look for this symbol to point out important safety precautions. It means attention!!! Your safety is involved. Page 1 RULES FOR SAFE OPERATION The purpose of safety rules is to attract your attention topossible dangers. The safety symbols and the explanations withthem, require your careful attention and understanding. The safety warnings by themselves do not elimimate any danger. The instruction o

Скачали: 22   Размер: 2 mb   Производитель: Ryobi  
Категория: Рубанки
@name

Throw-Back The throwing back of a workpiece usually caused by the workpiece being dropped into the blade or being placed inadvertently in contact with the blade. Workpiece or Material The item on which the operation is being done. Worktable Surface where the workpiece rests while performing acutting, drilling, planing, or sanding operation. FEATURES PRODUCT SPECIFICATIONS Feed Rate26 FPM No Load Speed10,000 RPM Motor2 HP Peak Input120 Volt, 60Hz, AC Only, 15 Amps Max Planing Height6 in. Max. Pla

Скачали: 10   Размер: 2 mb   Производитель: Ryobi  
Категория: Рубанки





Категории