Войти:
Сортировка : Названию ↑   Загрузкам   Оценке   Размеру ↑  

Jonsered CS 2137

Скачали: 163Размер: 552 kb    Производитель: Jonsered  
Категория: Бензо и электропилы

Francais Avant d’utiliser cet appareil, veuillez lire attentivement les instructions et assurez- --vous de les avoir comprises. Deutsch Lesen Sie diese Hinweise zur Handhabung des Gerats aufmerksam durch. Verwenden Sie es erst, wenn Sie sicher sind, da. Sie alle Anweisungen verstanden haben. Espanol Lea atentamente las instrucciones y asegurese de entenderlas antes de utilizar esta unidad. 530163281 12/11/02 2 IDENTIFICATION (WHAT IS WHAT?) Chain Adjustment Tool (Bar Tool) Primer Bulb Starter Fu

Jonsered CS 2141

Скачали: 72Размер: 2 mb    Производитель: Jonsered  
Категория: Бензо и электропилы

Please read the instructions carefully and make sure you understand them before using the saw. Always wear: • Approved protective helmet • Approved hearing protection • Protective glasses or visor Both of the operator.s hands must be used to operate the chain saw. Please see page 30 in your ”Chain saw operator's safety manual”. Never operate a chain saw holding it with one hand only. Please see page 30 in your ”Chain saw operator's safety manual”. Contact of the guide bar tip with any object sho

Jonsered 2045

Скачали: 61Размер: 1 mb    Производитель: Jonsered  
Категория: Бензо и электропилы

4 Start the saw and apply full throttle. Release the throttle control and check that the chain stops and remains stationary. If the chain rotates when the throttle is on idle setting you should check the carburettor idle adjustment. See the section on ”Maintenance”. 3 Chain catcher Check that the CHAIN CATCHER is not damaged and is firmly attached to the body of the saw. 4 Right hand guard Check that the right hand guard is not damaged and that there are no visible defects, such as cracks. 5 Vib

Jonsered RS44/52

Скачали: 55Размер: 1 mb    Производитель: Jonsered  
Категория: Машинки для стрижки

If the high speed jet H is set too lean (screwed in too far) the engine speed will be too high and cause engine damage. Do not let the engine run at full speed for more than 10 seconds. Apply full throttle and turn the high speed jet H very slowly clockwise until the engine slows down. Then turn the high speed jet H very slowly anticlockwise until the engine starts to run unevenly. Now turn the high speed jet H slowly clockwise a little way until the engine runs smoothly. H Note that the engine

Jonsered LT2115A

Скачали: 52Размер: 1 mb    Производитель: Jonsered  
Категория: Газонокосилки

LT2115A PRODUCT NO. 960 11 01-82 401433 11.14.05 VB PRINTED IN THE U.S.A. REPAIR PARTS TRACTOR - MODEL NO. LT2115A (96011018200), PRODUCT NO. 960 11 01-82 SCHEMATIC 03054 (197428) BATTERY FUSE IGNITION SWITCH RED RED RED BLACK IGNITION UNIT HEADLIGHTS BLACK BLACK BLACK WHITE WHITE WHITE RED BLACK ORANGE BLACKBROWN BLACK BLACK BLACK STARTER M SEAT SWITCH (NOT OCCUPIED) GROUNDING CONNECTOR ATT'MENT CLUTCH (CLUTCH OFF) CLUTCH / BRAKE (PEDAL UP) SOLENOID BLACK A AMMETER RED G B S M A1 A2L HOUR METER

Jonsered GR 2026D

Скачали: 50Размер: 2 mb    Производитель: Jonsered  
Категория: Садовые инструменты

speed, left/right handles, min: At max. speed, left/right handles, max: GR 2026D 1,64/26,9 1,38/35 1,10/28 2 700 11 000-11 700 10 000 0,9 KW/ 9 000 rpm Yes Yes Walbro CD Champion RCJ 7Y NGK BPMR7A 0,02/0,5 Walbro WT 1,06/0,5 13,2/6,0 93/99 2,0/2,2 2,2/3,0 1,8/2,1 2,5/3,6 GR 2032D 1,88/30,8 1,38/35 1,26/32 2 700 11 000-11 700 10 000 1,1 KW/ 8 400 rpm Yes Yes Walbro CD Champion RCJ 7Y NGK BPMR7A 0,02/0,5 Walbro WT 1,06/0,5 14,3/6,5 90/100 2,5/2,5 3,0/3,5 2,0/2,0 5,1/4,9 GR 2036 2,21/36,3 1,50/38 1

Jonsered SM 2055 E

Скачали: 39Размер: 2 mb    Производитель: Jonsered  
Категория: Бензо и электропилы

SM 2055E TABLE OF CONTENTS Introduction ....................................... 3 Symbols ............................................. 4 Warning Signs ................................... 4 Safety Regulations ............................ 5 Description ........................................ 7 Installation ....................................... 16 Fuel Handling .................................. 21 Starting and Stopping.....................23 Use.................................................

Jonsered CS 2165

Скачали: 39Размер: 2 mb    Производитель: Jonsered  
Категория: Бензо и электропилы

(See the section on ”How to avoid kickback”.) 1 Basic safety rules 1 Look around you: • to make sure there are no people, animals or other objects nearby that might affect your work. • to make sure that none of the above might come within reach of your saw or be injured by falling trees. Follow the instructions above, but do not use a chain saw in a situation where you cannot call for help in case of an accident. 2 Do not use the saw in bad weather, such as dense fog, heavy rain, strong wind, in

Jonsered BC 2125

Скачали: 36Размер: 2 mb    Производитель: Jonsered  
Категория: Машинки для стрижки

The risk increases at low temperatures. Quick release There is an easily accessible, quick release fitted at the front as a safety precaution in case the engine catches fire, or in any other situation that requires you to free yourself from the machine and harness. See instructions under the heading Adjusting the harness and clearing saw. Check that the harness straps are correctly positioned. Once the harness and machine have been adjusted, check that the harness quick release works correctly.

Jonsered 2054

Скачали: 35Размер: 2 mb    Производитель: Jonsered  
Категория: Бензо и электропилы

3 You can also use the chain brake as a temporary brake when you change position or if you put the saw down for a short time. You should also apply the chain brake manually if there is a risk of the chain accidentally hitting anyone or anything close by. 4 To release the chain brake pull the front hand guard backwards, towards the front handle. 5 As mentioned in section A, kickback can be very sudden and violent. Most kickbacks are minor and do not always activate the chain brake. If this happen





Категории