Войти:
Скачали: 0   Размер: 950 kb   Производитель: Linear  
Категория: Автоматические ворота
@name

The controller can also be set to prevent the gate from opening if the shadow loop is triggered while the gate is at the close limit position. This prevents a swing gate from opening into a vehicle if it’s parked near the gate on the inside. Low Power Mode This function is only used with DC slide gate Model SLD. The factory default disables the Low Power Mode.When Low Power Mode is enabled, and AC power fails, the controller will assume Low Power Mode after 60 seconds of gate inactivity. Low pow

Скачали: 0   Размер: 3 mb   Производитель: Cosco  
Категория: Автоматические ворота
@name

PART NO. DESCRIPTION NO. PART NO. DESCRIPTION 1 2100-1778-PLT Control Box Wrapper 17 2200-873-PLT Control Box Hinge, female 2 2100-1762 Terminal Strip Bracket, output side (riveted to control box) 3 2100-1761 Terminal Strip Bracket, input side 18 2200-874-PLT Control Box Hinge, male 4 2300-735 Heyco Bushing, 1.09 diameter (riveted to operator frame) 5 2200-122 Heyco Bushing, .87 diameter 6 2500-1948 Control Board Standoff 19 2500-1966 2 Amp Fuse for Control Board 7 2510-268 Control Board 20 2500

Скачали: 0   Размер: 950 kb   Производитель: Linear  
Категория: Автоматические ворота
@name

DC AC ACCESSORY POWER PROVIDES 24 VOLT DC POWER FOR ACCESSORIES. (.5A MAX) DC + RESET RESET BUTTON FACTORY CONNECTED TO THE CONTROLLER’S RESET BUTTON. COMMON B COMM LINK FOR 3-WIRE NETWORK CONNECTION TO SECOND OPERATOR IN DUAL GATE INSTALLATIONS. A COMMON CONNECT TO NORMALLY OPEN SWITCH FOR SINGLE BUTTON OPERATION. ALTERNATES SINGLE BUTTON INPUT BETWEEN OPEN-CLOSE OR OPEN-STOP-CLOSE DEPENDING ON PROGRAMMING. COMMON SINGLE FIRE BOX INPUT CONNECT TO NORMALLY OPEN SWITCH IN FIRE BOX FOR FIRE DEPART

Скачали: 0   Размер: 3 mb   Производитель: Cosco  
Категория: Автоматические ворота
@name

In the OFF position, the operator is set for right-hand. #5 When turned ON, this switch will allow a one-second delay for solenoid locks to unlock before the motor starts. #6 In the ON position, the reverse delay is three seconds. In DC operators only, this also disables the inherent DC brake (provided the R2 brake resistor is cut, see picture above). In the OFF position, the reverse delay is 1 1/2 seconds and the DC inherent brake is enabled. #7 Not used at this time. #8 This switch is used to

Скачали: 0   Размер: 3 mb   Производитель: Cosco  
Категория: Автоматические ворота
@name

CASNOVIA, MI 49318 • U.S.A. UL325 COMPLIANCE REQUIRES THE USE OF CONTACT EDGES OR PHOTOELECTRIC CONTROLS ON ALL AUTOMATIC OR REMOTELY-CONTROLLED GATE OPERATORS. Oct. 2005, Rev. 9 SLR • SLC • SLD OPERATOR INSTALLATION GUIDE TABLE OF CONTENTS PRE-INSTALLATION INFORMATION Gate Operator Classifications ......................................................................................................................................................... 3 Safety Information and Warnings ............

Скачали: 0   Размер: 950 kb   Производитель: Linear  
Категория: Автоматические ворота
@name

• Stagger Mode The Stagger Mode function determines if the operator has a delayed open or a delayed close. In dual swing gate installations, typically one operator is programmed for delayed open, and the other operator is programmed for delayed close. • Stagger Delay Time The Stagger Time sets the length of the delay for the Stagger Mode. See Pages 11, 13, & 14 for details on these three dual gate programming functions. Set the following parameters in each gate operator individually in a single

Скачали: 0   Размер: 5 mb   Производитель: GTO  
Категория: Автоматические ворота
@name

Keep in mind that the gate operator is just one component of the total gate operating system. Each component must work in unison to provide the consumer with convenience, security, and safety. This manual contains various safety precautions and warnings for the system designer, installer, and consumer. Because there are many possible applications of the gate operator, the safety precautions and warnings contained in this manual cannot be completely exhaustive in nature. They do, however, provide

Скачали: 0   Размер: 4 mb   Производитель: GTO  
Категория: Автоматические ворота
@name

Disconnect operator ONLY when the gate is NOT moving. TO MANUALLY OPEN AND CLOSE THE GATE: 1. Lift quick release pins UP, then pull them OUT of chain brackets. 2. Lay chain down and manually slide gate to desired position. Series GTO, Inc. Tallahassee, Florida USA SL .. Conforms to UL 325 STANDARDS Certified to CAN/CSA-C22.2 No.247-92 • Fingers, hands, and loose clothing may be dragged into chain sprockets. • Fingers and hands can be injured by rotating sprockets. • Keep hands, fingers, and loos

Скачали: 13   Размер: 5 mb   Производитель: GTO  
Категория: Автоматические ворота
@name

You agree to properly install this product and that if you fail to do so GTO, Inc. shall in no event be liable for direct, indirect, incidental, special or consequential damages or loss of profits whether based in contract tort or any other legal theory during the course of the warranty or at any time thereafter. The installer and/or user agree to assume responsibility for all liability and use of this product releasing GTO, Inc. from any and all liability. If you are not in agreement with this

Скачали: 0   Размер: 4 mb   Производитель: GTO  
Категория: Автоматические ворота
@name

Do not exceed 1000'. NOTE: Pull approximately 1 foot of extra low voltage wire into the control box to accommodate terminal connections. To maintain adequate charging power, use appropriate gauge, stranded, direct burial wire (see Accessory Catalog). Do not use telephone wire or any solid core wire because it will not provide adequate current. Never splice wires together. RED BLK ORG BLU GRN CLS EDG OPN EDG RED GRN ORG BLU WHT BLK ORG BLU GRN CLS EDG OPN EDG LEARN AUTO CLOSE INERTIA STATUSSTATUS





Категории